Receiver Setup
Guides

DISH Receiver Setup for Carryout Anser

DISH receivers will often not show when they are on signal if they have incorrect “Check Switch” information. For this reason, DISH users must clear current settings before pointing. To do this for most DISH receivers, follow these steps. The following instructions are based on a ViP 211 receiver. If your receiver differs from the options shown, you may need to consult your receiver menu. The wording and display used in your receiver may differ slightly.

For Help, Call 800-788-4417

STEP 1: Before starting, disconnect coax from "Sat In" on back of receiver. Press Menu on your remote. Select option 6, System Setup.

Instruction Manual for DISH Users

Elevation Maps