Part ID

[cbdeajr]

I have a 2001 Winne that I am starting to upgrade the TV's in. There is a Winegard push button switch that I do not know what it is for. The antenna coaxial come to and a coaxial cable out to the switching system. However there is 2 additional wire coming from it. The part number on it is #2700610. I have attached a picture of it.
Thanks
Cecil D

[Winegard Tech Help]

Cecil,

Could you possibly get some pictures of the connectors on the back? It almost looks like the board that's on the back of our wallplate power supplies but it's hard to tell from this angle.

[Bill Adams]

That appears to be the 12V power supply for your over the air roof mounted TV antenna (likely the Bat-Wine Sensar antenna). If we are seeing all of the cables, you have one coax that runs from the antenna on the roof to that circuit board and the circuit board sends 12V up that coax to power the amplifier in the head of the antenna. That 12V power is supplied by the yellow and while wires. The second coax goes from the circuit board to a video control center where you can select which output you would like to send to the TV (Cable, Sat, TV, VCR, etc). To power the roof mounted antenna you must push that little button and a tiny LED should light to indicate the antenna is power and you would only need to turn if off the you are going to park the coach and not use it so as to prevent that 12V draw from draining your batteries in time.

[cbdeajr]

Hope this one is OK

[cbdeajr]

Thanks
Cecil