Need dimensions for Trav'ler 1000 Interface panel

[Instr_Tech]

I am planning my installation of a Trav'ler Dish Network Sat antenna, and need the mounting dimensions for the interface box (panel) which is mounted inside the RV. Can one of the Wingard techs help me with dimensions/mounting of panel? I can't find any dimensional specification info. regarding the interface box on the Winegard website.

Thank you,
Instr_Tech

[skypilot]

The "Box" or panel is approximately 6" W x 8" D x 2.5 H. The wire loom & power from a power brick are connected to the "Box". If exact measurements are required I will get them for you. I think that the measurements are in the instructions. Have a good one Louie

[Instr_Tech]

Thanks for the come-back, Skypilot. If it's not too much trouble, I would appreciate an exact height measurement, the other dimensions are not important to me. Is the Interface unit just a rectagular box that sits on a shelf or does it have a face flange around the front so it can be screwed into a rack or panel?

Instr_Tech

[Bill Adams]

It is a box designed to sit on a shelf. It's 6" wide and 2" high. It's about 6" deep allowing clearance for the plugs in the back.

[Winegard Tech Help]

Instr_Tech,

Sorry for the delay on this - I just measured one in our office. It's 6" wide, 2" tall, and 5 1/2" deep.