MS-2000 & Splitter.

[Leigh]

My MS-2000 is doing a good job bringing in local channels when connected directly to my TV.

I'm getting a DVDR/VCR that has an Antenna In, and "pass Through" Out terminal/s for connection to the TV set.

Aternatively I could use a Splitter after the Amp output of the MS-2000, and run two seperate cables from the Splitter to the DVDR/VCR, and to the TV.

Which of the above would result in the least signal loss????

Thanks,
Leigh

[winegard]

I would take the one line to the DVDR/VCR and then out to the TV. The only exception to this is if that DVDR/VCR is located far away from the TV and you are adding a large cable run to take it there and back.