 |  |  |  |  |
WINEGARD COMPANY
Manufacturer of High Quality Television Reception Products
Attention New Users: We have upped the security on new member registrations in an attempt to stop spam posting. Please contact us if you are having problems joining the forums.
AP-8275 pre-amp
2 posts • Page 1 of 1
AP-8275 pre-amp
by kenjroy » Sun Oct 25, 2009 10:30 am
I have a Wineguard HD7697P antenna mounted on a 40 foot tower, and want to install a Wineguard AP-8275 pre-amp. Will the pre-amp be harmed if I install a signal splitter in my antenna downlead coax (for second TV) ahead of the pre-amp? I assume, in that case, pre-amp DC voltage would travel to the mast-mounted pre-amp and also to the second TV set (through split coax).
- kenjroy
- Posts: 1
- Joined: Sun Oct 25, 2009 10:15 am
Re: AP-8275 pre-amp
by winegard » Wed Oct 28, 2009 9:18 am
Good morning Kenjroy -
I don't believe it would be harmed, but your signal will be. You will want the pre-amp and power ahead of your splitter on the antenna side.
Antenna > Pre-Amp > Power > Splitter > TV's
I don't believe it would be harmed, but your signal will be. You will want the pre-amp and power ahead of your splitter on the antenna side.
Antenna > Pre-Amp > Power > Splitter > TV's
- winegard
- Site Admin
- Posts: 265
- Joined: Fri Jan 30, 2009 3:10 pm
2 posts • Page 1 of 1
Return to HDTV Home Antenna Technical Support
Who is online
Users browsing this forum: No registered users and 1 guest
|
Products Mobile Products HDTV Home Antenna Home Satellite Medical Telemetry |
Support Knowledge Base Site Map Product Registration Warranty Claim |
Winegard Company About Us Contact Us Career Opportunities Privacy Policy |
Winegard Company has been the leading manufacturer of quality television reception products since 1954. HDTV Antenna, Satellite, UHF, VHF,
Digital, Indoor, Outdoor, Mobile, RV, Internet, Phone, High Definition, Home,
Radio, Amplified, Wireless, Broadband, DTV, Dish, Over The Air, TV, Television © 2009 Winegard Co. All Rights Reserved |