Carryout GM-1518

[JohnnyA]

We recently purchased the Carryout in Texas while on a trip and it set up very easily. However, on after the check switch was performed, it only shows the 110 and 119 satellite as being green and okay. The 129 satellite is shown in red with an 'X'. On the point dish strength meter the 129 is green and locked. I am using a Dish Network VIP 612 receiver, but only a single feed in connection to SAT 1 Not using the splitter on the back, since there is only one satellite in use a time. The check switch did show the SW64 switch. Just wondering if this is normal or there is something I need to do different to have the 129 satellite signal go green on the check switch section of the setup.

Thanks.

[Winegard-Mobiletech]

For now, that is normal.

Some DISH Network receivers will have this issue with the SW64 switch. It will correct itself when DISH finishes their software update.