sk3005

[kbrad7472]

Can you use a SWM LNA with the 3005 It would save having to only run one wire into the RV instead of 4. also could you use the new 3LNB SWM getting only 101,99,and 103

[Winegard-Mobiletech]

Neither of these LNBF's will work with the SK-3005.

You can use the 8 way switch to split the signal after the coax leaves the TRAV'LER.

[rvtechhelp]

Correct set up with a HD receiver that has wrote by the sat in 1 (SWM) . Select Slimline-5 with nothing after it. Then you toggle down once and press select, then select Multi-switch not SWM. once that's done go to continue on the same screan and select. That's how to set it up correctly. You still connect 2 coaxes to the receiver if has, sat in 1 and sat in 2, besure to use the B-Band converters. By the way if SWM gets picked the receiver will only out-put voltage to the receiver for 1 to 2 minutes. The SWM-8 multi-switch and the power supply would cost almost $200.00. So follow the instructions and save.