I cannot get a signal on my digital converter box. I have a model RV 6004 antenna. Here is what I know so far
The box is between the power switch and the tv and the power switch is on (green light is on). All of the connections are correct. attenna to box (in), box to TV (out). The TV is set to Antenna and channel 3. The converter box reads "no signal", and cannot find any stations during a scan. Changed direction on the antenna. No change.
I tried by-passing the installed coax from the antenna by running cable from the attenna to the power switch, the rest remained wired the same. No signal. Note: Did not snake new cable, just ran it from the roof through the entry door to the back of the power switch per the Winegard wiring diagram.
The TV itself works fine in the house when connected to cable.
Help!!!
