Connect the coax cable running from your OTA antenna to the OTA input on the back of your receiver. If your receiver does not have an integrated off-air input, the MT2 Over-the-Air (OTA) Module is available, which would allow the addition of two OTA tuners to your DISH receiver.
Press Menu on your remote. Select option 6, System Setup.
Select option 8, Local Channels.
Select Scan Locals.
The receiver will now scan for local channels.
Once completed, the receiver will display the number of local channels found. Select OK.
The local channels found will be displayed on the left.
Highlight each channel to see the signal strength of each available channel.
Select Done. Then, the receiver will save information about the local channels.
Press Cancel twice to exit the menu. Press Guide on your remote; the local channels will be displayed in yellow.